Jump to content


Photo

Xecuter Switch Kit


  • Please log in to reply
2 replies to this topic

#1 kneelmesh

kneelmesh

    X-S Member

  • Members
  • Pip
  • 66 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 11 September 2003 - 07:44 PM

I have a xecuter 2.0 lite and I just recieved the switch kit so I can flash without taking apart my xbox every time.

Now the question. There are three sets of wires: a red set, blue set, and green set; but which set goes to which jumper on the chip?

Thanks in advance.

#2 CaliSurfer008

CaliSurfer008

    X-S Knowledgebase

  • Members
  • PipPipPipPipPipPipPipPip
  • 4,458 posts
  • Interests:Brahm is a whore
  • Xbox Version:v1.0

Posted 11 September 2003 - 11:22 PM

why would you have to take your xbox apart every single time? For flash protection?

If the switches are unmarked, you can connect the wires to whichever you want, knowing that when you flip that swtich, it'll disable/enable which jumper it is connected to

#3 kneelmesh

kneelmesh

    X-S Member

  • Members
  • Pip
  • 66 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 12 September 2003 - 01:46 AM

Nevermind, I figured it out using the picture at system-mods. The colors of wires are different but I assume the pattern is the same.

red set: bank selector
blue set: on/off
green set: flash protect





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users