Jump to content


X2.2l+, D0 Light...

  • Please log in to reply
3 replies to this topic

#1 phyzfer


    X-S Young Member

  • Members
  • Pip
  • 32 posts

Posted 17 November 2003 - 11:15 PM

Hi everyone...

I wanted to know a few things...

X2.2L+ on a 1.0v Box. I got the chip in, but only two lights...i searched and searched through many forums for similar questions...but nothing...I have no clue how to get the yellow light (LED4) on. I was thinking of soldering (I shoulda bought a solder-chip) the d0 point and placing the chip ontop of the solder point...

does anyone think this may cause problems?? Is it doable?



ps. i got the soldering iron and am ready to solder! woohoo :-)

#2 clindst


    X-S Enthusiast

  • Members
  • 28 posts

Posted 18 November 2003 - 12:47 AM

keep trying...i had the same problem it took me a few minutes to get the d0. look to see if the pogo pin is aligned just right

#3 Palmore



  • Members
  • PipPipPipPipPip
  • 1,517 posts
  • Location:Columbus, Ohio
  • Xbox Version:v1.0
  • 360 version:unknown

Posted 18 November 2003 - 02:49 AM

make sure the mod chip is disabled via the front switchs, that will keep it from lighting while you try and seat it properly..
first x2.2 pro I did took awhile to line up right =/

#4 phyzfer


    X-S Young Member

  • Members
  • Pip
  • 32 posts

Posted 18 November 2003 - 03:16 AM

thanks to both of you...in the end, i had to use a square blade..and it seemed like that did the job (i guess there was still some coating left on the d0 point)



0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users