Jump to content


Xecuter Solder Prob

  • Please log in to reply
No replies to this topic

#1 raredesign


    X-S Member

  • Members
  • Pip
  • 68 posts

Posted 21 November 2002 - 04:33 AM

ok, i installed the xecuter 1.0 (how can anyone say it was easy....well, i am a beginner.) i am getting the red and green blink. i read that it is because of a bad connection, but i was wondering, what would happen if some of the solder points are touching? like underneith the chip, i can't really see, so what if some of the joints are touching?...would that cause that prob?

also the u-shaped part is not screwed in...it is soldered instead...is taht a prob?

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users