Jump to content


Photo

X2.3b Pro, D0 2 Wire, But 3 Pins On Chip


  • Please log in to reply
2 replies to this topic

#1 CaviarBag

CaviarBag

    X-S Enthusiast

  • Members
  • 16 posts

Posted 31 January 2004 - 11:29 AM

I have installed several X2.2 and X2.3B pro chips using the same method, pin header. On this 2.3B Pro the connector on the chip for D0 and ground has three pins, while the wire connector has only 2. Its only been 2 on both before as far as I remember.

Since I'm using pin header, can I connect D0 on the wire install without using the other wires?

CaviarBag

#2 guy3685

guy3685

    X-S Enthusiast

  • Members
  • 3 posts

Posted 31 January 2004 - 11:55 AM

It should have came with a 3 pin connector. 1 wire is the d0 point and the other 2 go to the ground screw.


Guy

#3 CaviarBag

CaviarBag

    X-S Enthusiast

  • Members
  • 16 posts

Posted 31 January 2004 - 08:54 PM

Ok, I attached D0 to the wire-install connector D0 wire and ground, cut off the other wires.
So, using pin headers on LPC, and connected D0 and ground to the wire-connector works, nema problema.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users