Jump to content


Photo

X2.3b Pro Frag


  • Please log in to reply
5 replies to this topic

#1 fuzion_

fuzion_

    X-S Enthusiast

  • Members
  • 22 posts

Posted 27 February 2004 - 12:20 AM

Ok, i just installed my 2.3b pro in my xbox. Hooked everything up and booted it up.

It works when the mod chip is disabled (boots just like normal) yet it reboots 2 times and FRAGS when it is enabled.

I gathered from reading certain things that this means my d0 point is ok? What else could be the prob?

Thanks

*edit* by the way, the led on the switch isnt working for some reason mad.gif

Edited by fuzion_, 27 February 2004 - 12:26 AM.


#2 xboxzombie

xboxzombie

    X-S X-perience

  • Members
  • PipPip
  • 385 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 27 February 2004 - 01:11 AM

do the lights on the chip turn on? make sure connections are good ?

#3 fuzion_

fuzion_

    X-S Enthusiast

  • Members
  • 22 posts

Posted 27 February 2004 - 01:41 AM

There are no lights on the X2.3B Pro

Least i dont see any. And if there are, then none come on

The light on the external switch doesnt come on either. Everything is connected correctly.

#4 xboxzombie

xboxzombie

    X-S X-perience

  • Members
  • PipPip
  • 385 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 27 February 2004 - 01:46 AM

did you use wire or pinheader install? check to see if any lpc points are bridged if you have no lights on your chip than somthing is not hooked up right is you d0 in the right spot ?

#5 fuzion_

fuzion_

    X-S Enthusiast

  • Members
  • 22 posts

Posted 27 February 2004 - 06:24 PM

Pin Header - i'm gonna check the soldering job... the d0 is in the right spot

#6 fuzion_

fuzion_

    X-S Enthusiast

  • Members
  • 22 posts

Posted 28 February 2004 - 02:57 PM

Problems have been fixed! Thanks all! biggrin.gif




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users