Jump to content


Photo

Tsop Flash Froze


  • Please log in to reply
2 replies to this topic

#1 sNiPPs

sNiPPs

    X-S Member

  • Members
  • Pip
  • 64 posts

Posted 10 April 2004 - 03:11 PM

So I was flashing my friend's TSOP (v1.0 Hynix chip). I soldered the top and bottom of the mobo no problem. I plugged in my chameleon, connected the A15 and D0 points. I booted up my cham to bank 3 which had the evox d6 TSOP bios in it. It detected bank 0 as the Hynix chip. I went to flash it and it got 1/4 of the way done erasing it and completely froze. Now the box frags on non mod boot, or booting with the evox d6 tsop bios. I can boot it using an xecuter2 bios with the chip, but the cham is my only chip and I want to keep it to do other TSOP flashes. If I try flashing bank 0 from the cham is says the chip is AMD(cham chip). Any suggestions or do I have to give my friend the chip?

#2 Arakon

Arakon

    X-S Hacker

  • Members
  • PipPipPipPipPipPip
  • 2,336 posts

Posted 10 April 2004 - 03:22 PM

the tsop is likely empty, in that case the only way to recover it is a 30 wire eprom/flashrom mod.


#3 Soup

Soup

    X-S Senior Member

  • Members
  • PipPip
  • 244 posts
  • Xbox Version:v1.0

Posted 10 April 2004 - 09:18 PM

29-wire, actually. Like this: http://www.xraychips.com/Xray3.htm




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users