Jump to content


Photo

You've Probably Heard This Alot


  • Please log in to reply
1 reply to this topic

#1 TB2ZI

TB2ZI

    X-S Expert

  • Members
  • PipPipPip
  • 730 posts
  • Location:Vancouver, Canada
  • Xbox Version:v1.3
  • 360 version:v1 (xenon)

Posted 07 May 2004 - 02:00 PM

I'm just about to install LEDs into my controller ports, using this tutorial. So, all I do is solder the negative side of the LED to the shielding and cut the red wire (5v, correct me if i'm wrong) and add a resistor to it and connect the other end of the resistor to the positive end of the LED?

P.S. San I put heatshrink/electrical tape over the resistor?
**EDIT**
Which tut is brighter? this or this?

Edited by TB2ZI, 07 May 2004 - 02:16 PM.


#2 2nue

2nue

    X-S Young Member

  • Members
  • Pip
  • 56 posts
  • Location:ID
  • Xbox Version:v1.0

Posted 07 May 2004 - 02:14 PM

i used this tut no cutting any wires, if u want to check it out, but ya according to the tut u found just cut the 5v, and u can cover the res.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users