When flashing my 1024k bios I have it set so that just DIP switch 4 is on and the chip is disabled, so that's fine. Then if I have a 1024k file..I try booting up EVOX with only DIP switch 3 on and the chip is enabled. I haven't tried a 512k bios yet but like I said ...I open the 256k across all 4 banks, read it, flash it, and verify it and all is well. It's this damn red/;orange flashing thing. Another reason can be bad connections but I wouldn't be able to flash and detect and verify it through x2 BIOS manager if the soldering was jacked up right? So I'm just thinking BIOS. Also, I did get the Cromwell BIOS load up after I installed the chip < I just chose to do the LPT/parrallel cause of ease, and X2 BIOS can detect the chip (x2.3b pro) so d0 shoud be fine too as well as all connections.
Edited by louisj23, 10 June 2004 - 06:40 PM.