Jump to content


Photo

Yep I Finally Fried One!


  • Please log in to reply
6 replies to this topic

#1 the_fly_guy

the_fly_guy

    X-S X-perience

  • Members
  • PipPip
  • 327 posts

Posted 03 September 2004 - 02:59 AM

i was doing a chip on a v 1.6 everthying was going ok after a few minor bumps but i finally got the chip in then poered the chip then it booted to the m8 bios so i put the hard drive in and the dvd in put all the screws in then i press power and nothing, but the chip still powers on when it gets pluged in and the power supply fuse is still good but it is dead for good i think?

#2 thewickedjester

thewickedjester

    X-S Knowledgebase

  • Members
  • PipPipPipPipPipPipPipPip
  • 4,012 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 03 September 2004 - 03:42 AM

it sounds like something is not properly grounded, check all your connections.

and i know this sounds stupid, but make sure that your eject panel is plugged in properly

#3 the_fly_guy

the_fly_guy

    X-S X-perience

  • Members
  • PipPip
  • 327 posts

Posted 03 September 2004 - 06:06 PM

yeah the eject panel is good bad grounding could be the answer maybe because it is a v1.6 mobo in a v1.0 case and it dosnt fit 100% corectlly

#4 thewickedjester

thewickedjester

    X-S Knowledgebase

  • Members
  • PipPipPipPipPipPipPipPip
  • 4,012 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 03 September 2004 - 07:54 PM

yeah, the cases were slightly different, try taking out that metal sheild (if you havent already) that might be causing something to ground that shouldnt be.

#5 the_fly_guy

the_fly_guy

    X-S X-perience

  • Members
  • PipPip
  • 327 posts

Posted 04 September 2004 - 02:16 AM

well i tried putting back in the original case and still got nothing

#6 mynuffinfutsitch

mynuffinfutsitch

    X-S Genius

  • Members
  • PipPipPipPip
  • 862 posts

Posted 04 September 2004 - 02:18 AM

switch the bank and try flashing another bank

#7 thewickedjester

thewickedjester

    X-S Knowledgebase

  • Members
  • PipPipPipPipPipPipPipPip
  • 4,012 posts
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 04 September 2004 - 02:21 AM

what chip did you use? i wonder if when you did the lpc rebuild that is necissary for the 1.6, when you screw the motherboard down some wires get connected/disconnected or something like that.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users