Jump to content


Photo

Quick Matrix Question


  • Please log in to reply
1 reply to this topic

#1 sheliak

sheliak

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,520 posts
  • Location:Earth
  • Xbox Version:none
  • 360 version:none

Posted 16 September 2004 - 05:27 PM

What versions does the solderless Matrix work with? I heard the D0 point was moved after v1.1. If I run a wire from the new D0 to the Matrix, will that work?

#2 Exzir

Exzir

    X-S Expert

  • Members
  • PipPipPip
  • 533 posts

Posted 16 September 2004 - 08:38 PM

matrix is solderless install on 1.0 and 1.1 and 1.6.

Some soldering will be needed to be done on the motherboard to the chip 1.2 and up for d0 execpt 1.6 since it does not have a d0 but you will need a soldering iron to remove the d0 pogo pin. Solder to the mother board will need to be done on the mother board for a 1.6 however the matrix will still screw on the motherboad and will not need to be soldered to anything. Hince the phrase solderless install.

To install a matrix on to a 1.6 folow the cheap mod rebuild of the lpc and then screw the matrix on.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users