Jump to content


Photo

Xecuter Wire


  • Please log in to reply
3 replies to this topic

#1 Shadow_Mx

Shadow_Mx

    X-S Member

  • Members
  • Pip
  • 71 posts

Posted 10 August 2002 - 02:36 AM

Yeah, where those the wire gets solder to.
I see the point on the mobo, but its confusing on the diagram, does it gets soldered to the same spot as the swith? or where to???

please help.

#2 themenace

themenace

    X-S Enthusiast

  • Members
  • 22 posts

Posted 12 August 2002 - 05:13 PM

I need to know this too! If you see the diagrams at the x-ecuter website the wire lead to the switch connection part but this shouldn't be soldered according to another diagram at their website (if don't want a switch of course), but where to connect the wire too?

TIA

#3 xmods

xmods

    X-S Young Member

  • Members
  • Pip
  • 48 posts

Posted 13 August 2002 - 05:02 AM

If you are not going to use the switch to switch between the retail and x-ecutor bios's you'll need to jumper the 2 contact points with solder then attach the wire to the solder, make sure the 2 points are connected after you attach the wire or else it won't work. What you are doing is simply grounding out the retail bios so when you boot the console it doesn't see the onboard retail bios, it sees just the x-ecutor bios. Hope this helps ya out some. Take care

#4 Shadow_Mx

Shadow_Mx

    X-S Member

  • Members
  • Pip
  • 71 posts

Posted 14 August 2002 - 12:09 AM

I plan to use the switch...so where does the wire goes??
to the "black" arrow in the diagram? if so, wouldn't there be some problems if the cables touch each other???


thx




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users