Jump to content


Photo

Lpc Question


  • Please log in to reply
1 reply to this topic

#1 hackme

hackme

    X-S Member

  • Members
  • Pip
  • 93 posts

Posted 11 October 2004 - 01:49 AM

sad.gif I have a vers. 1.5 Box with a 2.3bPro installed. i got lights on my chip but it resets three times then FRAGS. All my LPC voltages check out EXCEPT for pin #7 which is the Lad3. It's supposed to be 3.3v but its showing as 0.00v on my multimeter.

My question is, if the LPC is no good can I place it in another 3.3v hole in the LPC thats not being used? uhh.gif

#2 SAETNETA

SAETNETA

    X-S Young Member

  • Members
  • Pip
  • 34 posts
  • Location:Jackson, TN
  • Xbox Version:v1.1

Posted 11 October 2004 - 07:49 AM

I've had the same problem -- You probably broke a trace leading to the LPC. Look online to see which trace leads to your LPC. Then buy some small insulated wire from radio shack, etc. and solder a connection from the nearest hole in the trace to the LPC. You'll want to check voltage after you make your connection... also check the resistance -- with the xbox off -- it should be very close to 0 ohms.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users