Jump to content


Photo

Bad Chip, Or Bad Solder Job?


  • Please log in to reply
1 reply to this topic

#1 Big O

Big O

    X-S Enthusiast

  • Members
  • 4 posts

Posted 20 October 2004 - 11:49 PM

I attempted a POGO install, I had no success. After reading through xbit forum, I thought it might be a connectivity issue so I asked and a technician friend to do the soldering for me. Now, when xbit chip is enabled my Xbox intermittently powers OFF, ON, OFF, ON, OFF three times then gives me the red and green Christmas lights. When I flip the switch to disable chip, MS BIOS load just fine. I donít think I have bogus BIOS. I get my xbit to successfully flash and verify different BIOS on different banks.

I have an XBIT 1.0, XBOX version 1.5. I tried EvoX M7, M8, X4983.06, and X4983.67 BIOS with no luck. Do I have a bad chip or bad solder job?

I'm leaning towards a bad solder job. The D0x is a bitch to solder, so damn small.

#2 Palace

Palace

    X-S Enthusiast

  • Members
  • 18 posts

Posted 25 October 2004 - 01:33 PM

Have you scrapped the top of the Do point as it has a light covering over the board scrap it gentley of with a small screwdriver. it should go a brown colour..

Hope this helps! wink.gif




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users