Jump to content


Xecuter 3 Fragging

  • Please log in to reply
3 replies to this topic

#1 SubZero7


    X-S Enthusiast

  • Members
  • 1 posts

Posted 15 November 2004 - 09:12 AM

when i boot up my xbox it boots fine with my properly flashed x3 in it. but often i will push the button and it will jus frag and same thing next itme i turn it on and after that it will boot up fine??? is it my d0 point or my pin header? or jus sodder in general?

#2 el_diablo


    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,614 posts
  • Location:Melbourne, Australia
  • Xbox Version:v1.5

Posted 15 November 2004 - 11:06 AM

i would resolder the pinheader and while your at it you might as well do the do smile.gif

#3 stillbored


    X-S Enthusiast

  • Members
  • 14 posts

Posted 15 November 2004 - 04:57 PM

It's probably just your pinheader...if it's not soldered in exactly correctly, it can be pushed to the side by the DVD drive, which is what happened in mine.



    X-S Senior Member

  • Members
  • PipPip
  • 234 posts

Posted 23 November 2004 - 03:59 AM

mine works fine for about twenty min's then it starts to frag. I unplug it and walk away for about ten min's and then all is fine again.

I have solidered it three times and still the same results.

Could it be the chip with the problem????

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users