Jump to content


Photo

Up And Running


  • Please log in to reply
4 replies to this topic

#1 D_Sanchez

D_Sanchez

    X-S Young Member

  • Members
  • Pip
  • 39 posts

Posted 15 December 2004 - 06:44 AM

Alright so here it is. I started the install using the 1.6 adapter. After several hours of messing with that, I decided it was header pin time. I followed the DMS3 header pin diagram as far as orientation of the chip. I used the Xenium LPC rebuild pic (easy/bottom side of MoBo) and the Smart XX d0 point to ground (screw hold pad).

Flashed the chip in option 6 using bank 4 to load m8_16 bios. I tried the standard, plus, and metoo versions of the bios and had no luck.

Flashing was accomplished on a Compaq and a Dell both running XP with DMS3 new 1.5 software version. I had issues flashing on my ASUS and Toshiba computers.

Granted you cannot turn your chip off, but at least it works.

This information came directly from a tutorial (kmoob: thanks)

#2 bucko

bucko

    Super Moderator

  • Head Moderators
  • PipPipPipPipPipPipPipPipPipPipPip
  • 7,997 posts
  • Gender:Male
  • Location:England
  • Xbox Version:v1.6
  • 360 version:v5.0 (360S - trinity)

Posted 15 December 2004 - 09:37 AM

cool.gif great work, though you may want to flash Evox M8_16plus if you have hynix ram.

#3 herb1

herb1

    X-S Enthusiast

  • Members
  • 4 posts

Posted 20 December 2004 - 03:57 PM

but where have the header-pins to go through??
i think like in picture 1, but in that case the "warning point" has got a pin...

uhh.gif uhh.gif uhh.gif

user posted image

#4 herb1

herb1

    X-S Enthusiast

  • Members
  • 4 posts

Posted 20 December 2004 - 06:37 PM

anyone?... sad.gif

#5 D_Sanchez

D_Sanchez

    X-S Young Member

  • Members
  • Pip
  • 39 posts

Posted 22 December 2004 - 08:11 AM

Sorry for the delay in the answer but I just saw it. You are correct that there would be a pin in the warning spot. Just clip it off and you will be fine. Others on the board said they just bent it over, but I actually clipped it on my install.

And it is the header pins on the first pic, not the second.

Edited by D_Sanchez, 22 December 2004 - 08:12 AM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users