Jump to content


Enigmanh: It Boots And Then.../how To Flash?

  • Please log in to reply
No replies to this topic

#1 nice


    X-S Enthusiast

  • Members
  • 1 posts

Posted 16 August 2002 - 11:14 AM

First of all, I guess I have a bad solder point somewhere.

The Xbox boots fine, I can boot the EvoX cd and after a few moments the picture starts to flicker, turns green blink.gif and then the picture goes bye-bye. To be able to have picture again I have to remove the power cable or let the box be turned off for a while.
Am I right if I say that a cable loses it's connection when it gets hot?
Any ideas?

Then, if I get things to work that is, I want to flash the bios with EvoX.
A couple of guides says I have to cut the wires or use a switch while it's running. How on Earth am I supposed to cut the wires under the M/B? Any suggestions how to do? Do I really have to cut the wires before I flash, why isn't it possible to do the flashing while the Enigmah chip is running?

Thanks for your help!

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users