is this all i need to do ?
clean the d0 and the other points on the MB
dab a small amount of solder on each point where a wire will be connected
get chip ready
reheat the first solder point and stick the wire in it?
the flux will help to keep solder off the MB right? if a little gets on there before it hardens could this be bad?
when i read heat the solder point is this talking about the solder that you would put on it?i pictured touching the MB with the solder pin. thats bad right?
i have a 1.1 and i think im just going to get the X2 lite.
with these sites getting shut down and the guy getting busted it makes me think i better go ahead and get my chip.
Edited by Suicide_Row, 27 February 2003 - 10:43 PM.