Jump to content


Photo

Now Holes(e&c) On Mb For Spider Chip Wires


  • Please log in to reply
2 replies to this topic

#1 Levinemr

Levinemr

    X-S Enthusiast

  • Members
  • 1 posts

Posted 22 January 2005 - 09:06 PM

I am trying to install a spider chip v1.0 on a v1.6 xbox; however, the holes, identified in the manual, aren't punched out. can i use a needle of something to punch them out or am I out of luck? thanks



#2 MasterChief777

MasterChief777

    X-S Enthusiast

  • Members
  • 22 posts
  • Interests:Halo 2......
  • Xbox Version:v1.0

Posted 23 January 2005 - 03:16 AM

ya i have the same problem i also broke a freaking wire from the spiderchip grr.gif ...plz help


#3 woodall1

woodall1

    X-S Young Member

  • Members
  • Pip
  • 36 posts

Posted 23 January 2005 - 04:31 AM

I had the same problem last night with my spiderchip. I tried to solder the wires to the board, no joy. I also had problems with the chip mounting to the MB properly. I think that was a lot of the issues with my install. It worked fine when the chip was turned off. As soon as I cut it back on I got the red/green flash. I pulled the chip out and ordered a Xecuter 2.6 w/ programmer. Maybe it will be a little better quality. The idea of just sticking the wire in the holes with no real way to secure them is a bad idea in my opinion.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users