Jump to content


Photo

Pin Out Diagram For Header?


  • Please log in to reply
4 replies to this topic

#1 Scrufdog

Scrufdog

    X-S X-perience

  • Members
  • PipPip
  • 350 posts
  • Location:Baltimore, MD
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 07 June 2005 - 07:00 PM

Does anyone know what pins out the adapter are for power/ground?

Im trying to figure out why i can never get the led on my cham 1.5 to light up, or go mode 4 writable, even though everything else seems to work.

I'd like to make sure I'm getting power where power needs to be.



#2 MonsterTy

MonsterTy

    X-S Expert

  • Moderator
  • PipPipPip
  • 538 posts
  • Location:Lafayette, Indiana
  • Xbox Version:v1.4
  • 360 version:v1 (xenon)

Posted 11 June 2005 - 03:29 AM

If you have not done so, please check this guide : Chameleon LE/S P&E Installation Manual . It may have the answers you are looking for as far as mode 4 is concerned.

#3 Scrufdog

Scrufdog

    X-S X-perience

  • Members
  • PipPip
  • 350 posts
  • Location:Baltimore, MD
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 12 June 2005 - 03:29 AM

yeah, thanks for that, but i had those all taken car of.

Ive been able to flash the bios twice now, but only after a fight both times.

the LED still doesnt light up ever.

I was trying to see what i could test on the pins themselves to verify the chip was at full potential.



#4 MonsterTy

MonsterTy

    X-S Expert

  • Moderator
  • PipPipPip
  • 538 posts
  • Location:Lafayette, Indiana
  • Xbox Version:v1.4
  • 360 version:v1 (xenon)

Posted 12 June 2005 - 03:38 AM

I apologize for just pointing you at the manual, I guess I was misunderstanding what you are looking for. What version of motherboard does your XBox have? I assume you would know if it was a 1.6 to rebuild the LPC, but you also have to get your ground and power on a 1.5 board. Although I imagine if you had the 1.5 and had not done so, you would never have been able to flash the BIOS in the first place.

Edited by MonsterTy, 12 June 2005 - 03:38 AM.


#5 Scrufdog

Scrufdog

    X-S X-perience

  • Members
  • PipPip
  • 350 posts
  • Location:Baltimore, MD
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 12 June 2005 - 04:49 PM

Ok, I put my specs in my sig.

Dont apologize, your trying to help. I appreciate that.

Anyway, what I'm looking for is a pin-out diagram/schematic for the adapter thats soldered to the mobo. The adapter that the chameloen plugs into. I'm trying to see if everything is properly connected, no bad contacts/lifted tracks.

Specifically, I'd like to know what pins are power and ground for it. If anything can be checked and verified with a multimeter, that as well. I dont want to go poking around with a meter and risk messing up anything.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users