Jump to content


Photo

Happy Happy Joy Joy


  • Please log in to reply
1 reply to this topic

#1 Scrufdog

Scrufdog

    X-S X-perience

  • Members
  • PipPip
  • 350 posts
  • Location:Baltimore, MD
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 07 June 2005 - 08:49 PM

So in the past few days of looking and searching the figure out whats going on with this damn chip, I learned something today. The LED must be hosed on my Cham 1.5

I took things apart once again today and found the my E point wire has come off the resistor. So i undid the E+P points from the board and redid them to the wires. Switched to mode 4, booted normally, no LED. Tried yet again to Flash Bank 2 with Evox8+ and I saw my very first xbox bios flash progress bar. SWEET. It usually would just sit there at Erasing with no bar. Rebooted and success, the Evox logon was on the boot screen.

now I need to get the 137GB hard drive thing going on the this and I'll be set.

Thanks to those few who helped me the past couple of days, and thanks to the forums in general.



#2 Scrufdog

Scrufdog

    X-S X-perience

  • Members
  • PipPip
  • 350 posts
  • Location:Baltimore, MD
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 07 June 2005 - 09:03 PM

WTF

damnit

im trying to reflash after using evtools and now its doing the same crap all over again, just freezes on the Erasing part.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users