Jump to content


Photo

Few Questions...


  • Please log in to reply
3 replies to this topic

#1 oddmoen

oddmoen

    X-S Enthusiast

  • Members
  • 4 posts

Posted 11 June 2002 - 10:45 PM

hi i have two questions
1. wich mod chip i need 5V ,12V i know that it have to be 256kb or higher!
2. i have downloadet a file named "working xtender 1,1.bin" is this the right file?? (256kb)
if i have the wrong file please email me the right file odd29@lycos.com

ciao

#2 DeMOnS

DeMOnS

    X-S Member

  • Members
  • Pip
  • 135 posts

Posted 11 June 2002 - 11:20 PM

The chips 'working' voltage would have to be 5V, as that is the line you pick up from the X-Box mobo.

Dont know if anyone has found a 12V pickup yet, I guess there must be one somewhere. I know for sure there is a 3.3V line on the board (Very near the 5V one that xtender uses).

Good luck.




#3 oddmoen

oddmoen

    X-S Enthusiast

  • Members
  • 4 posts

Posted 12 June 2002 - 11:51 AM

right image??

#4 DeMOnS

DeMOnS

    X-S Member

  • Members
  • Pip
  • 135 posts

Posted 12 June 2002 - 11:35 PM

Filename looks right but there are alot of fake images kicking around (Why people do it is beyond me).

Open the image file you have in a hex editor and go to offset $CFA (Hex) and you should see the m$ copyright message the bytes following the message are :-

2E 82 04 D4 2E

This can be confirmed by looking at the Hex dump 'snippet' that remains on 'bunnie's' Site (after m$ asked him to remove the full image).

Not much to go on but its better than nothing.

Hope it helps.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users