Jump to content


Photo

No Power After A Case Swap?


  • Please log in to reply
4 replies to this topic

#1 THX Aces Full

THX Aces Full

    X-S Enthusiast

  • Members
  • 4 posts

Posted 01 October 2005 - 07:33 PM

I just switched my reg Xbox case with my friends clear case. After a few problems the switch went fine. The clear one works great. The other worked fine at first. I hooked it all up and plugged it in without the top just make sure it all worked. Everyting was fine. I put the lid on and now no power. No anything. I can hear a hum coming from the power supply and I checked the connection from the power button assembly to the mother board and everything looks fine. Anyone ave any advice?

#2 Modderxtrordanare

Modderxtrordanare

    X-S Freak

  • XS-BANNED
  • PipPipPipPipPip
  • 1,795 posts
  • Location:Haha
  • Xbox Version:unk
  • 360 version:unknown

Posted 01 October 2005 - 07:35 PM

Short somewhere
What version is the mobo and what version is the case?

#3 SICKdimension

SICKdimension

    X-S Messiah

  • Head Moderators
  • PipPipPipPipPipPipPip
  • 3,659 posts
  • Gender:Male
  • Location:California
  • Interests:TO IM ME, STATE YOUR REASON, DON'T JUST SAY "HEY R U THERE?"
  • Xbox Version:v1.4
  • 360 version:v1 (xenon)

Posted 01 October 2005 - 07:46 PM

Most likely it is a 1.6 mobo in a pre-1.6 case, in which case, there is a small transistor you will need to replace.

#4 THX Aces Full

THX Aces Full

    X-S Enthusiast

  • Members
  • 4 posts

Posted 01 October 2005 - 07:50 PM

really? Shit. Is there a way to look at it and figure out if its bad? which one is it?

#5 SICKdimension

SICKdimension

    X-S Messiah

  • Head Moderators
  • PipPipPipPipPipPipPip
  • 3,659 posts
  • Gender:Male
  • Location:California
  • Interests:TO IM ME, STATE YOUR REASON, DON'T JUST SAY "HEY R U THERE?"
  • Xbox Version:v1.4
  • 360 version:v1 (xenon)

Posted 01 October 2005 - 08:21 PM

http://xbox-scene.com/versions.php
First determine that it is a 1.6 mobo. If so, to determine if it is bad, you will need a multimeter. If you don't have a multimeter, you can pretty much assume that is the problem, cause you have all the symptoms of it.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users