Jump to content


Photo

Xecuter 3 Chip Installed... But Problems


  • Please log in to reply
4 replies to this topic

#1 KiZ

KiZ

    X-S Enthusiast

  • Members
  • 8 posts

Posted 19 November 2005 - 09:29 PM

[edit: sorry, I just realised i put this in the wrong forum]


As I was installing my xecuter xhip I did have some problems, especially with the soldering. I thought I had sorted them though. I also managed to drop my harddrive on the floor when taking my dvd drive to reinstall.

When I press the power button, the switch panel shows red, and after about 1 second, it reboots. after is has booted up 3 times, it stays up, but the chip still shows red and the xbox led blinks green/red

Is this caused by the d0 wire not being connected properly?

or a hdd fault?


or none of the above? (in which case I must have borked something else up in the install)

Edited by KiZ, 19 November 2005 - 09:34 PM.


#2 00g

00g

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,069 posts
  • Location:P.V.B. Fla
  • Xbox Version:v1.6
  • 360 version:v1 (xenon)

Posted 19 November 2005 - 09:32 PM

it's fragging. You need to check all your solder points.

I know this sounds so vague, but it's really hard to say which connection it is.

Just check and re-check all of them.



#3 KiZ

KiZ

    X-S Enthusiast

  • Members
  • 8 posts

Posted 19 November 2005 - 10:04 PM

ok, would the d0 cause fragging?

or is it lpc only?

#4 pirateninjagraf

pirateninjagraf

    X-S Young Member

  • Members
  • Pip
  • 31 posts

Posted 20 November 2005 - 03:06 AM

if it frags, the d0 has to be correct. like he said, check all your points.

#5 Dano2k0

Dano2k0

    The Cooling King

  • Moderator
  • PipPipPipPipPip
  • 1,457 posts
  • Xbox Version:unk
  • 360 version:unknown

Posted 20 November 2005 - 11:48 PM

QUOTE(pirateninjagraf @ Nov 20 2005, 02:13 AM)
if it frags, the d0 has to be correct. like he said, check all your points.

View Post



If it frags it could most deffinatly be a D0 issue, but is also very likely to be a LPC issue, make sure none of the traces on the motherboard are damaged also and none of the smaller components have been knocked off the motherboard either.

I recommend making sure there are no shorts on the joints, and make sure all the connections are good on both the LPC and D0, also if your xbox is a V1.6 make sure your using the 5V mod wire aswell on an X3.

If your out of luck and live in the UK drop me a PM or email through our website, we offer a very professional repair service in the UK.

Best of luck fixing your problems beerchug.gif




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users