Jump to content


Photo

Red Orange Frag With Chip On.


  • Please log in to reply
3 replies to this topic

#1 ncaissie

ncaissie

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,052 posts

Posted 19 January 2006 - 03:14 AM

Hi

I just installed my Xenium (blue) into my 1.4

Now Iím getting a red Ė orange frag whit the chip.

When I lift the chip from the pin header it boots normal.

I tried the following but it didnít work:
http://www.xbox-scen.../red-orange.php

Any Ideas?

Do you think itís the chip?

I had an Aladdin XT in there and it worked fine. After the swap this started.

If no one knows Iíll try the Aladdin again. I just didnít want to take it out of the other box again.


Thanks

#2 Rabid1

Rabid1

    X-S Expert

  • Members
  • PipPipPip
  • 546 posts

Posted 19 January 2006 - 03:45 AM

HAve you made sure the chip isn't switched to recovery mode?

#3 ncaissie

ncaissie

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,052 posts

Posted 19 January 2006 - 01:21 PM

Of course.

I have had this chip since the day it was released.


The OS on the chip works fine. I can add bios's and the retail k to the launch menu.

When you boot from the retail via the chip it frags orange and red. When I pull the chip off the pinheader it boots fine.

It also frags orange red when I boot from a bios on the chip.



#4 Rabid1

Rabid1

    X-S Expert

  • Members
  • PipPipPip
  • 546 posts

Posted 19 January 2006 - 06:42 PM

Normally when you can get to the OS but no bios launch there is a problem with the install. I would check all the solder points on the lpc, or remove and resolder.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users