Jump to content


Photo

Converting A 1.6 Psu To Be Used With 1.0-1.5 Mobos


  • Please log in to reply
1 reply to this topic

#1 Chamrock

Chamrock

    X-S X-perience

  • XS-BANNED
  • PipPip
  • 351 posts
  • Xbox Version:v1.6
  • 360 version:v3.0 (falcon)

Posted 27 March 2006 - 10:26 AM

If I remember correctly the 1.6 PSU feed the 1.6 mobo with 5 volt from one of the wires while 1.0-1.5 needs 3.3 volt. Could you please show me a simple diagram for a regulator and which voltage pin that should be regulated? Some caps and a regulator is what i need I suppose.

Could a LM1117MP do the job? What caps would I need?

#2 pablot

pablot

    X-S Freak

  • Moderator
  • PipPipPipPipPip
  • 1,275 posts
  • Location:Sweden
  • Xbox Version:v1.6
  • 360 version:none

Posted 27 March 2006 - 11:33 AM

yep, that one should do. Check the datasheet for the cap values, but one 1117 datasheet I have looked at recomended 100nF on the input and 10uF on the output.

You also need to swap some wires.. check http://psu.pablot.com to se how.

I haven't tested it and there could be a problem with the PS_OK signal, but I don't think so.

Good luck and report back how it whent!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users