Jump to content


Xenium White Fried?!

  • Please log in to reply
2 replies to this topic

#1 fireviper024


    X-S Young Member

  • Members
  • Pip
  • 38 posts
  • Interests:LEARN TO SOLDER!!!!!!!!!!!!!!!
  • Xbox Version:v1.0
  • 360 version:none

Posted 31 March 2006 - 06:53 PM

So I had this X White Chip That was laying around. I had pulled it out of a buddys system and it was working when it can out. It sat for a few months before I tried it out. I swaped out my chip for this one, soldered the DO wire to the back side of the chip, and just put it on my existing pin header. I Turned it on, and the the box turned off and on 3 times and then started flashing. I fliped the dip switch on the chip and rebooted. It booted to the Orignal Bios. Then I smelled something burning, so I shut down, pulled the chip and the dam thing burned me. Anyone????

#2 Rabid1


    X-S Expert

  • Members
  • PipPipPip
  • 546 posts

Posted 31 March 2006 - 08:05 PM

sounds like you had it on the wrong pins.

#3 JonBOY


    X-S X-perience

  • Members
  • PipPip
  • 441 posts
  • Location:Australia
  • Xbox Version:v1.4
  • 360 version:unknown

Posted 04 April 2006 - 06:35 AM

the chip should have been sitting on the pinheader as close to th front of the box as possible. The 'X' in the word Xenium should also have been toward the back of the xbox, what pins did you use and in what orientation did you install it?

Edited by JonBOY, 04 April 2006 - 06:36 AM.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users