Jump to content


Photo

X2 - Lite Installation


  • Please log in to reply
1 reply to this topic

#1 kh44na

kh44na

    X-S Member

  • Members
  • Pip
  • 70 posts

Posted 30 April 2003 - 08:45 PM

Hey guys...

I have been reading up everywhere.....but whenever I think that I have FINALLY found out ALL the information I need to know - SOMEONE manages to tell me "not to forget this" - etc...etc..

I just want to make 100% sure about what is required of me for a complete installation and usage of the X2 LITE.

After soldering the wires to the board - since it is pre-flased I don't have to worry about installing a bios - so that's fine. After I finish soldering the wires to the motherboard, what else do I do? Just run my box and it should load up with the Executer Bios??

Please help me out - I would GREATLy appreciate your advice and help. Thanks in advance.

#2 Xeero

Xeero

    Welcome Back!

  • Members
  • PipPipPipPipPipPipPipPipPipPipPipPip
  • 8,413 posts
  • Location:Massachusetts
  • Xbox Version:v1.0

Posted 30 April 2003 - 08:49 PM

If you're just now getting an X2 Lite, chances are it will be pre-flashed with the Cromwell BIOS. In this case, you want to reflash the BIOS using OZXflash (read the readme that comes with it).




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users