Jump to content


Photo

X3ce Flashing Eject Button


  • Please log in to reply
3 replies to this topic

#1 skippie

skippie

    X-S Young Member

  • XS-BANNED
  • Pip
  • 34 posts
  • Xbox Version:unk
  • 360 version:unknown

Posted 22 April 2006 - 06:35 AM

Hello all,


I'm new here and have a question, I installed a X3ce in my machine with no problems, so i'm doing another for a friend, after hooking it all up i plugged it in, and the chip didn't com on, I took it all apart again, went over my soilering points and put back together, when i power it up all the lights on the chip are on, and the lights on the outside controler are on, if i power the machine with a long hold on the button it loads fine, BUT if i do the quick tap of the power button, the machine turns on and off 3 times, then stays on but theres nothin on the screen, and the control panel is red, and the eject button is flashing........

any idea's



Skippie


#2 Wireless Geek

Wireless Geek

    X-S X-perience

  • Members
  • PipPip
  • 317 posts

Posted 22 April 2006 - 11:46 AM

Check the solder points on the LPC. The D0 is working if it can boot to the MS Dash. What version board did you mod? Everything was solder, right? No solderlesss adapters.

-- Geek

Edited by Wireless Geek, 22 April 2006 - 11:50 AM.


#3 skippie

skippie

    X-S Young Member

  • XS-BANNED
  • Pip
  • 34 posts
  • Xbox Version:unk
  • 360 version:unknown

Posted 22 April 2006 - 12:06 PM

it's a 1.6.... no soilerless adapter, as far as i know it was soildered right





SKippie


#4 skippie

skippie

    X-S Young Member

  • XS-BANNED
  • Pip
  • 34 posts
  • Xbox Version:unk
  • 360 version:unknown

Posted 22 April 2006 - 04:46 PM

anybody?










0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users