Anyways, I've got an old server with a database on an old 20GB WD Hard Drive. It runs a POS system and its data is incredibly important. So, knowing that WD's love to burn out and it could happen at any time, I want to add another HD and set up a RAID 1 array. I've got two identical disks and a RAID card, but have never build an array from this point. I have always defined the array formatted and then built it up form there.
So my question is, where should I go from here? What is the best and easiest way to go from one disk to two in RAID 1?
Edited by mixman101, 18 May 2006 - 05:27 PM.