Jump to content


Xecuter2.1 Lite Switch Bank Connector

  • Please log in to reply
2 replies to this topic

#1 bark01


    X-S Enthusiast

  • Members
  • 4 posts

Posted 04 June 2006 - 08:58 PM

The connector between my chip and my switch bank melted....

The bit thats attached to the wires has melted so the actual switch bank is okay, but anyideas where i could get the connector from or even what its called, model number would be fantastice but if anyone knows what the general type of connector is called it would be very helpfull. Nothing works on my Xbox at the moment.

I've included a link to the bit i've melted, its the white connector on the top left of the chip as you look at it. the female part is okay i only need the male part.



Edited by bark01, 04 June 2006 - 08:58 PM.

#2 saint_river


    X-S Member

  • Members
  • Pip
  • 78 posts
  • Location:Leigh - Lancashire - UK
  • Xbox Version:v1.6
  • 360 version:none

Posted 04 June 2006 - 09:26 PM

you can buy a replacement switch from www.divineo.com

they are really cheap about 10 ($20 or thereabouts)

#3 bark01


    X-S Enthusiast

  • Members
  • 4 posts

Posted 05 June 2006 - 06:51 PM

its the connector that goes into the switch that needs replacing not the actual switch, I presume the switch comes with the female conector as soldered in but not the male connector, Its the male connector I need.

I've had a look at the diveno website but can't even find the switch. I've seen an excecutor switch on other websites switch but it doesn't look the same.

may have to just buy a whole new chip set.....

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users