Jump to content


Photo

How To Flash Spider Gx Chip


  • Please log in to reply
1 reply to this topic

#1 tonto26

tonto26

    X-S Enthusiast

  • Members
  • 7 posts

Posted 14 June 2006 - 12:43 PM

I recently purchased the Spider GX chip for my 1.5V xbox. I have finally figured out how to get to the spider gx os by NOT using the PCB board (white cuved looking thing) and instead just soldering a piece of wire to the D0 on the Chip and then into the motherboard. Anyway, once i get to the spider os menu, i can not move around in it. Is this normal? and how do i go about flashing the chip? i have read that some people are flashing by using a web method, but i am not familiar with this, so if someone could please help or point me in the right direction i would greatly aprreciate it. I am trying to install a 200gb drive also. i have burned a copy of the x2 4281 for the larger drive not sure of exactly the name but i think i have the right file. well i hope that someone can help me with this problem, thank you all in advance.

#2 X_Gamer7

X_Gamer7

    X-S Senior Member

  • Members
  • PipPip
  • 233 posts
  • Xbox Version:v1.0
  • 360 version:none

Posted 19 June 2006 - 10:58 PM

If the controller is not responding, it is more than likely the fact that you must use an official M$ controller. I had this same problem too, and switching to an official controller worked smile.gif




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users