Jump to content


Smartxx Lt Opx On V1.6

  • Please log in to reply
1 reply to this topic

#1 swale


    X-S Member

  • Members
  • Pip
  • 75 posts

Posted 21 August 2006 - 10:41 PM

I'm installing a SmartXX LT OPX on a V1.6 I have sperated the pin head from the rest of the chip. I have the location for the rest of the chip on the backside of the board. Is the Pin head needed or shall I discard this? I don't see what it does on a V1.6.


#2 XOR


    X-S Member

  • Members
  • Pip
  • 133 posts

Posted 22 August 2006 - 12:19 PM

If you have broken off the Pinheader, then all you need to do is solder the chip directly to the back of the motherboard.

look closely at the chip and you will see some '*' marks, these tell you where to put your solder, an install picture can be found on the main SmartXX website:

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users