Jump to content


Photo

Wont Shut Off


  • Please log in to reply
2 replies to this topic

#1 foe84

foe84

    X-S Member

  • Members
  • Pip
  • 97 posts

Posted 09 September 2006 - 01:33 PM

i put my duox2 cromwell chip in and now my xbox wont shut off when i press the bottom button. is it in wrong. i followed the diagrams i saw...i left the top 4 slots open. also, where is the alt. d0 point on an xbox 1.6 in a diagram it says its near point R7P4, which was near the xyclops chip and B7b1 i think. but there i cannot find it.


advice? thanks

#2 Chancer

Chancer

    Don't You Trust me?

  • Head Moderators
  • PipPipPipPipPipPipPipPipPipPipPipPipPipPipPip
  • 18,687 posts
  • Gender:Male
  • Xbox Version:v1.6
  • 360 version:v3.0 (falcon)

Posted 09 September 2006 - 03:09 PM

Make sure you have BT connected to the coreect point and not dropped any solder down the Power and eject board when soldering BT.
There is an install guide in my signature g, go through the install again and double check every point

#3 blame canada

blame canada

    X-S Hacker

  • XS-BANNED
  • PipPipPipPipPipPip
  • 2,356 posts
  • Location:Good ol' Chicago
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 09 September 2006 - 03:10 PM

You probably soldered the BT point to the power button. While looking at the back of the P/E board, make sure the BT wire is on the top left solder joint on the eject button. Bah, beaten to it.

Edited by blame canada, 09 September 2006 - 03:11 PM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users