Tutorial to make the Light bar Always On
As you can see on the schematics, the leds get fed 12V through a 300ohm resistor. There are fuses on both pin connectors, don't know what ampage they are rated for. As you can see the source is not found yet, but its a PWM signal. My first guess was that it was the RTC chip was the source, but we couldn't find anything. We are looking in to it. If you want the LEDs to be constantly on you can just connect TP52 to ground, not though that you will loose the protection of the fuse on that side (shouldn't be a problem).
How to have the fan always on to prevent overheating
I suspect that this will be a heavy moderated thread, don't go too of topic, the mods can gather the info up to this first post.
Edited by pablot, 06 August 2007 - 09:18 AM.