1st time i noticed the unusual freezing is when i 1st tried using MC360's newest, after switching 2 blades to the right, it froze. Then i tried again, and froze again after going in media. Then each time i tried using AMT+Accuview scripts, it freezes everytime.
Update- I cleaned everything a 2nd time now, and noticed so far it's not freezing now. Go figure, all i did was a fresh install, same as 1st time, but this time it's working so far. Weird
Edited by djdafreund, 17 February 2007 - 07:27 AM.