Jump to content


Photo

Problem Flashing Ms28


  • Please log in to reply
3 replies to this topic

#1 dannyglass

dannyglass

    X-S Young Member

  • Members
  • Pip
  • 44 posts
  • Location:UK, Kent
  • Xbox Version:none
  • 360 version:v1 (xenon)

Posted 21 February 2007 - 09:27 AM

I attempted to flash my toshiba-samsung MS28 with the Xtreme hacked firmware 5.2, i used Xtreme Boot Maker V0.5.3 RC1 to create the basic disk i applyed bokes patch and used custom controller, then i turned the pc off and connected the xbox 360 drive to my pcs onboard sata my motherboard is the DFI Lanparty NF4 SLI-DR, i then turned on the pc and booted from the usb drive then i turn on the xbox 360 and type in xread it lists the sata port so i type in 3 and turn off the 360 wait ten seconds and turn it back on and nothing happens in dos it doesnt try updating or anything it just seems to hang, Can anyone tell me what the problem is please?

Thankyou.

#2 mr-blonde

mr-blonde

    X-S Member

  • Members
  • Pip
  • 139 posts
  • Location:Peterborough ENGLAND
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 21 February 2007 - 10:23 AM

You need a Via 6421 sata chipset to flash a ms28 any other chipset will give you problems
you can get a via pci card for about 12

#3 dannyglass

dannyglass

    X-S Young Member

  • Members
  • Pip
  • 44 posts
  • Location:UK, Kent
  • Xbox Version:none
  • 360 version:v1 (xenon)

Posted 21 February 2007 - 11:23 AM

Cant i use the bad flash method though? or the vcc method though?

#4 Nexi

Nexi

    X-S Senior Member

  • Members
  • PipPip
  • 159 posts
  • Location:Eastern PA | NYC
  • Xbox Version:v1.1
  • 360 version:v1 (xenon)

Posted 21 February 2007 - 11:28 AM

Bad Flash Recovery mode only works if you have a VIA chipset. Also in your original post, you're not following the procedure correctly.

1) Turn on PC and 360 without the SATA plug connected to the 360 (SATA PLUG SHOULD NOT BE CONNECTED)
2) When you get to the DOS prompt plug the SATA cable from the PC into the 360






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users