Ps3 Controller Taken Apart, Cant Find Where Piece Goes
Posted 08 March 2007 - 05:30 AM
It is a small black "T" shaped part which has small prongs on the tip of each of the three T's. In the intersection of the "T" is a round piece with an indent on one side and a cone on the otherl. I can't find where it goes.
All of the buttons seem to press just like on his other controller so I'm thinking it doesn't go with any of the buttons. If any of you guys know where this part goes please let me know.
Posted 08 March 2007 - 05:40 AM
Just found a picture of it, It is the part in the lower left corner.
I appreciate any help you guys have.
Posted 08 March 2007 - 07:20 AM
Posted 18 March 2007 - 05:40 PM
The tabs between the L1/L2 and R1/R2 aren't too bad if you put it all together with the L1 and R1 buttons removed, so ya have a little more space to mess with them, then L1 and R1 just snap back in after the controller is all together.
Posted 12 April 2007 - 01:20 AM
Posted 12 April 2007 - 06:18 PM
hey man where does that piece go??? i have the same situation my damn dog knocked over a cup of juice on my controler and i have it together except that "T" piece i think it fell off the button pad but i didnt see a good spot for it and honestly i didnt see a good spot for it anywhere in the controller... if ya could help me it would be appreciated... thanks
It goes on the d-pad, I have an original ps one controller (oldskool ) and it also has the t-piece.
Posted 12 April 2007 - 09:02 PM
Posted 12 April 2007 - 09:34 PM
hey man thanks a lot i got it in place and the controller works...
No prob, I also had troubles mounting that thing on my controller
Posted 22 October 2008 - 02:03 AM
so, i have the same problem. the part fell out of the controller as i was taking it apart. it was under the D-pad, so i knew that was were it came from in the first place. i didn't get a chance to find out how it fits under the d pad though. i'm pretty sure it's inbetween the white rubber part and the d-pad, but which way do the prongs face? the front (d-pad) or back (rubber)?
also, what orientation is the T shape suppose to be in? does it actually fit in like a T, or and upside down T? or does it point to left or right?
Posted 22 October 2008 - 03:15 AM
1. place the front shell for the controller face down. the back of the bottons should be on your left, the d-pad on your right.
2. place the 4-way d-pad into its slot.
3. place the t-shaped object so that the prongs are facing the front of the controller. the T shaped object will actually go in diagonally, like and upside-down y. the center prong will go in the lower right (lower left from this view, closest to the hole for the left analog. three corners of the d-pad will have a prong, the only one without will be the upper left (the corner furthest from the left analog)
4. place the white rubber piece on top of the d-pad, with the black plastic bits facing up (away from the d-pad)[/b]
Posted 28 October 2008 - 12:07 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users