Jump to content


Photo

Duox2 1.6 Install


  • Please log in to reply
3 replies to this topic

#1 cubsfan23

cubsfan23

    X-S Enthusiast

  • Members
  • 5 posts

Posted 18 March 2007 - 11:53 PM

when installing the lpc rebuild do you first solder the pin header to the motherboard or the lpc rebuild to the motherboard?

#2 jwhazel

jwhazel

    X-S Young Member

  • Members
  • Pip
  • 31 posts

Posted 19 March 2007 - 08:14 AM

Carefully solder the pin header (make sure the solder is very thin, just enough to make contact) to the motherboard. Then install the LPC rebuild.

#3 appleguru

appleguru

    an Apple a Day...

  • Members
  • PipPipPipPipPipPip
  • 2,694 posts
  • Location:Colorado Springs, CO Boston, MA
  • Xbox Version:v1.6
  • 360 version:v1 (xenon)

Posted 19 March 2007 - 09:45 PM

I usually solder the pinheader and LPC rebuild at the same time, but that method makes most sense with 'open' rebuild pcbs like the xecuter ones... With the duox2 pcbs, LIGHTLY soldering the pinheader in first makes sense to ensure a good connection. Do NOT put too much solder on the first time though, or you wont be able to put the rebuild pcb down.

#4 _GhOsT_

_GhOsT_

    X-S Genius

  • Members
  • PipPipPipPip
  • 970 posts
  • Location:
  • Xbox Version:v1.6
  • 360 version:v4.0 (jasper)

Posted 20 March 2007 - 03:18 AM

just solder in the pin header then do the rebuild with wires
if the install goes bad with the rebuild board its way harder to take off, than wires would be




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users