Jump to content


Photo

Alladin Chip And Alternative D0


  • Please log in to reply
4 replies to this topic

#1 K@mui

K@mui

    X-S Young Member

  • Members
  • Pip
  • 49 posts

Posted 19 May 2008 - 06:48 PM

I have a prob with my alladin chip and it doesn't seem to start.
When i press the power button, Xbox tries to power up and then stops then tries again to power up and then stops again and finally tries one more....it starts working at the third time but nothing on the TV and green - red led alternating blinking.

I think that i damaged my D0 on the chip so is there any other D0 point on the chip ?

#2 HD10291

HD10291

    X-S X-perience

  • Members
  • PipPip
  • 360 posts
  • Location:Chi Town
  • Xbox Version:v1.2
  • 360 version:v3.0 (falcon)

Posted 19 May 2008 - 07:21 PM

There's only one D0 I'm aware of, what type of aladin? are you sure it's solder good on your mother board?

#3 K@mui

K@mui

    X-S Young Member

  • Members
  • Pip
  • 49 posts

Posted 19 May 2008 - 07:41 PM

Xm i don't know the kind because an other guy buy it and solder it yeeeeears ago.

No mobo solder is ok because couple ours ago worked fine and i just remove the wire only from the chip not from the mobo just to disable the chip and test my softmod

#4 HD10291

HD10291

    X-S X-perience

  • Members
  • PipPip
  • 360 posts
  • Location:Chi Town
  • Xbox Version:v1.2
  • 360 version:v3.0 (falcon)

Posted 19 May 2008 - 07:43 PM

Is the trace lifted where the D0 needs to be soldered? Post some high resi pics.

Edited by HD10291, 19 May 2008 - 07:45 PM.


#5 K@mui

K@mui

    X-S Young Member

  • Members
  • Pip
  • 49 posts

Posted 19 May 2008 - 08:40 PM

Ok here is the photos .... even in macro mode and still they are blurry

My chip, of course in this photo i don't have soldered any of the D0 points

IPB Image

As you see D0 is still silver but the prob is that the xbox tries to start 3 times and in the third time finally starts but no screeen and a red-green led

Also BT soldered on the chip's ground point. In photo seems that it is soldered in the point near by but it's not for sure (worked like this all the time)

Upper D0

IPB Image

Bottom D0 It worked with this one all the time

IPB Image

Edited by K@mui, 19 May 2008 - 08:48 PM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users