Jump to content


Photo

Trouble With My 555 Rf


  • Please log in to reply
3 replies to this topic

#1 killer skittle

killer skittle

    X-S Senior Member

  • Members
  • PipPip
  • 245 posts
  • Location:Atlanta, GA
  • Xbox Version:v1.2
  • 360 version:v1 (xenon)

Posted 23 November 2008 - 11:38 PM

I KNOW UR GETTING TIRED OF RF QUESTIONS, BUT.....

I have built a rapidfire controller successfully for my new cg board, but when i tune the pot to like 10-15 shots a second (rough estimate) the shots go crazy like skip shots and go fast then go slow the burst? is their any suggestions to keep it steady shooting?

#2 RDC

RDC

    X-S Seraphic

  • Head Moderators
  • PipPipPipPipPipPipPipPipPipPipPipPip
  • 8,782 posts
  • Gender:Male
  • Location:VA
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 23 November 2008 - 11:54 PM

It's also game dependent and what weapon you're using. A semi-automatic of full auto weapon isn't going to fire properly and a pistol is only going to be able to fire so fast anyway. If ya have the thing set too fast you'll be missing shots as the controller is going faster than the game can keep up with and it'll act up like that, slow it down some and see how it acts.

Edited by RDC, 23 November 2008 - 11:56 PM.


#3 killer skittle

killer skittle

    X-S Senior Member

  • Members
  • PipPip
  • 245 posts
  • Location:Atlanta, GA
  • Xbox Version:v1.2
  • 360 version:v1 (xenon)

Posted 24 November 2008 - 12:09 AM

i only use it for pistols in cod 4! but i can shoot normally faster with the trigger, than my rapid fire can without choking up and shipping, so i know it CAN shoot faster , do i need more resistors or something?

#4 RDC

RDC

    X-S Seraphic

  • Head Moderators
  • PipPipPipPipPipPipPipPipPipPipPipPip
  • 8,782 posts
  • Gender:Male
  • Location:VA
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 24 November 2008 - 12:29 AM

More Resistance or more Capacitance, take yer pick.

Use the Astable calculator HERE and plug in your values to figure out the rate of fire, Hertz is the number of times per second the Trigger is being pulled, then increase the Cap or Resistor value to change it. If ya put a POT in there ya can tune it that way.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users