Jump to content



Ps3 Rapid Fire Install

  • Please log in to reply
2 replies to this topic

#1 Truedef


    X-S Enthusiast

  • Members
  • 3 posts

Posted 26 November 2008 - 06:37 PM

I had a few questions about the PS3 rapid fire install.

The first is, may I connect the ground from the chip to one ground and the ground from the switch back to the same ground. Basically having both wires on the same ground, can I do that and not have any issues?

The second one is about the switch. There are five pins total, which ones do I cut off and which ones do I keep, the tutorial is not quite clear enough for me.

Lets use this below as an example:

: :

There are two on the left, two on the right, and one on top in the middle. Which ones do i use?

Thanks and I hope for a fast reply!

Edited by Truedef, 26 November 2008 - 06:42 PM.

#2 Truedef


    X-S Enthusiast

  • Members
  • 3 posts

Posted 26 November 2008 - 08:09 PM

here is the switch, which pins do i use?

IPB Image

#3 Definitely Wapner

Definitely Wapner

    X-S Senior Member

  • Members
  • PipPip
  • 182 posts
  • Location:New England
  • Xbox Version:v1.4
  • 360 version:v5.0 (360S - trinity)

Posted 27 November 2008 - 08:52 AM

I sold you the kit. I think I replied to you earlier. You use either the 2 on the left OR the two on the right. Do not use one of each and disregard the long pin.

And as far as the ground goes, anybody who buys my kits and installs this should not run into a problem using the same ground point on the NEWER sixaxis and Dualshock 3 controllers. The tutorial for the older controllers gives you 2 grounds, which were used merely for convenience sake.

Edited by Definitely Wapner, 27 November 2008 - 08:55 AM.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users