Problem With Jungleflash Seeing My Drive
Posted 08 March 2009 - 06:17 PM
I want to flash my BenQ that is already flashed.
I flashed a couple of drives in the past, I am not a complete newbie.
I plugged my xbox drive in my Via 6421 card. Then I boot my computer, open Jungle Flasher.
Then I get a message
No Comports were found during enumeration
Then an error
Windows Drive not ready. Exception Processing Message 0xc0000a3
Then the program opens.
I got in the MTKFLash table, there are 4 ports listed. 3 empty and the other one I only see this.
It doesn't look like the BenQ drive...
I also tried with Iprep, but when it tries to make the bootable USB drive, it crashes.
Maybe I am not pointing the good port? How can I know which Sata port my drive is plugged into? The Sata cable is plugged in the port that is the closer to the back of my computer and is facing me.
Thanks a lot!
I am running Windows Vista.
Posted 08 March 2009 - 07:12 PM
Edited by Traviss63, 08 March 2009 - 07:15 PM.
Posted 08 March 2009 - 10:16 PM
You dont have a Benq, you have a Lite On. This is the wrong area for this question. This area is for TECHNICAL inquiries.
Sorry, I taught I had the good section. Modified DVD Firmware.
In fact, it's a BENQ, but it was installed in a xbox that had a Liteon first.
My mistake was the framework 3.5 NET. It worked fine. After that flash, it says Verification Failed. I was very scared then... But everything is working perfectly now :-)
I flashed it with a BenQ firmware... Is it was I was supposed to do?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users