Posted 03 December 2009 - 01:48 AM
MFG is August 2009 am i screwd
Posted 03 December 2009 - 06:41 PM
Posted 03 December 2009 - 06:57 PM
If it is one of these new drives then the cut and solder solution is probably the only one we are going to get.
Posted 14 April 2012 - 09:31 PM
Can someone point me to a recent tutorial on how to do this?
Drive is a LiteOn DG-16D2S-09C with firmware 93450C manufactured October, 2009. It's mounted in a fat Jasper XBox 360.
Posted 14 April 2012 - 10:09 PM
Posted 15 April 2012 - 12:12 PM
Regardless, PMT/probe3 will work or ALL phat liteons.
Posted 15 April 2012 - 08:41 PM
+ you dont need to spend any money on stuff!.
The traces are very easy to cut....just make sure you have a sharp stanley blade and make two small cuts across the trace and the centre bit of trace will just pop up off the board leaving you a nice cut.
The soldering isnt hard either, plenty of space on each bit that needs soldering.
Just double and triple check that your solder hasn't bridged anything and that your cuts are clean and you cant go wrong.
long live the MRA!
Posted 15 April 2012 - 11:17 PM
Posted 15 April 2012 - 11:51 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users