Jump to content


Photo

Ben-q Wont Open


  • Please log in to reply
5 replies to this topic

#1 james513

james513

    X-S Member

  • Members
  • Pip
  • 92 posts

Posted 21 January 2010 - 02:15 AM

My 360 got knocked over. The drive wouldn't open anymore. So I opened it to see what was jamming it. I cleaned it put new grease on the gears. I played with it some more and if the top plate is on all the way it wont open at all if its up a little it will open fine. I looked on the underside of the top plate and nothing is scratched. I don't see anything catching.

Any ideas?

#2 TK-101

TK-101

    X-S Senior Member

  • Members
  • PipPip
  • 207 posts
  • Xbox Version:unk
  • 360 version:v3.0 (falcon)

Posted 21 January 2010 - 02:34 AM

I dnt no wat could be stopping your drive from opening.
Maybe the dvd case got dented or slightly bent.
Jus get another top, xcm maybe??

#3 james513

james513

    X-S Member

  • Members
  • Pip
  • 92 posts

Posted 21 January 2010 - 03:29 AM

I think that the tray holding the laser is not dropping down but not sure an xcm would be nice. When I lift the back up it works, something is catching in the back

Edited by james513, 21 January 2010 - 03:35 AM.


#4 TK-101

TK-101

    X-S Senior Member

  • Members
  • PipPip
  • 207 posts
  • Xbox Version:unk
  • 360 version:v3.0 (falcon)

Posted 21 January 2010 - 09:55 PM

U will jus have to try and opening the dvd drive with the top case on and inspect where it is gettin caught.
How about replacing the motor that controls the laser?

Edited by TK-101, 21 January 2010 - 09:58 PM.


#5 james513

james513

    X-S Member

  • Members
  • Pip
  • 92 posts

Posted 21 January 2010 - 11:08 PM

Finally got it to work, I cut the whole back off end so whatever was stopping it aint any more.

#6 TK-101

TK-101

    X-S Senior Member

  • Members
  • PipPip
  • 207 posts
  • Xbox Version:unk
  • 360 version:v3.0 (falcon)

Posted 22 January 2010 - 03:13 AM

That's good you should cover the back with something to avoid dust getting on the laser.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users