Jump to content


I Need Jtag Help/questions

  • Please log in to reply
No replies to this topic

#1 Superman2k2


    X-S Enthusiast

  • Members
  • 1 posts

Posted 11 March 2010 - 03:17 PM

I have a Xenon I was using Belenos guide. I was able to read my nand as the guide said I named them nand1,nand2 and nand3. I checked them with degrader and nand1 had 3 bad blocks nand 2 & 3 had none they matched. So in the guide after you do that you Extract KV and Config blocks from orig.bin so I figuered orig.bin is nand 1 so what i did was type this nandpro nand1.bin: -r16 rawkv.bin 1 1
nandpro nand1.bin: -r16 rawconfig.bin 3de 2 it all when smothly
after i did this and finshed the rest I did a power cycle. Before i Jtaged the Dash was 6xxxx when i booted it was 8xxx (dash) after a while I got a e79 error did I do somethingwrong ? I have the diodes on and pointed in the right dirrection but they are not soldered directly on the board its a cable the diode the cable, should it be straight on the board? should I have renamed nand 2 to orig.bin and used that? Please help me

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users