Jump to content


Cygnos V2 Rev F Installation Help

  • Please log in to reply
1 reply to this topic

#1 cregmac


    X-S Enthusiast

  • Members
  • 2 posts

Posted 20 May 2010 - 10:39 AM

Greetings, I have a CYGNOS V2 Rev F chip to install to a JASPER MO-Board.

First thing I noticed there is no ON/OFF switch sad.gif

Second Do I need to solder the GND also? In the video that was not done.

I went ahead and soldered the chip to the MO-Board and all the quick solder points but no BLU LED comes on

Any assistance will be greatly appreciated happy.gif

I can provide photos or whatever other information needed.

*Edit: I checked the solder points and added my own switch. Now the chip works.
Running parallels desktop on a mac virtual windows recognizes the CYGNOS chip.

New problem uhh.gif toolbox wont run huh.gif

Edited by cregmac, 20 May 2010 - 11:19 AM.

#2 letsmod


    X-S X-perience

  • Members
  • PipPip
  • 424 posts
  • Location:Northern Calif. (BAY Area)
  • Xbox Version:v1.6
  • 360 version:v3.0 (falcon)

Posted 15 August 2010 - 02:09 AM

rev F doesnt get a blue light and doesn't need a switch !! so most likely you just killed it!!

look at pic at cygnos site, NO SWITCH on there

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users