Jump to content


Photo

Jtag Falcon Took Out Dvd Drive Out Added Fans


  • Please log in to reply
No replies to this topic

#1 drvsbsm

drvsbsm

    X-S Member

  • Members
  • Pip
  • 85 posts

Posted 27 March 2011 - 09:47 PM

I just realized I posted this in the wrong forum. Mod please delete

I got a Jtag falcon took out DVD drive out and added 2 fans dropped my temps 10-15celcius

I already got pins 4 and 6 bridged so it boots fine into freestyle. Now I need help on which pins are 12v and ground so I can run my 2 extra fans from that. Running two 12volt fans from DVD power source should be fine right?

The problem is I got my fans running from a 12volt cord and they don't seem to be spinning as fast as the should.

I would rather use the power pins from the DVD drive power pin-out since I took it out of the 360.
and it kinda a pain to unplug the fans every time I shut the 360 off.

If someone could help me out with this I would appreciate it very much. I did a search but pin-outs give me about a million hits. and Ive been looking for awhile so I figured with this post that someone could help me out.

I need 12v pin and ground pin. I'm no good at soldering so I figured I would just run a rigged connector to the pins I need.

Or if some one could just point me to the thread or page that shows 12volt and ground pins.

Thanks in advance for any help.



I just realized I posted this in the wrong forum. Mod please delete

Edited by drvsbsm, 27 March 2011 - 09:51 PM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users