Jump to content


Ps3 60gb Help

  • Please log in to reply
3 replies to this topic

#1 LeHaM


    X-S Young Member

  • Members
  • Pip
  • 58 posts

Posted 11 August 2011 - 11:44 AM

ok i bought a 60gb ps3 and it arrived today,
the ps3 was booting when it was sent out (Registered post), it had a update loop, i told them to keep the hdd to save 10$ (i am a cheap skate) i bought it home today and went to boot it up and all i get is blue flashing light (drive mech is misaligned) trys to eject disc makes some noise. also it has a solid green light and sounds like a normal boot (like as in fans ect) then after 1mins or so it turns off to a solid red light as if i turned it off PS: during this there is no vid or audio. pls help
thanks in advance

#2 LeHaM


    X-S Young Member

  • Members
  • Pip
  • 58 posts

Posted 11 August 2011 - 11:20 PM

i have come to the conclusion that it has a faulty RSX BGA any one got any tips for reflow, im going to use no clean flux any ideas??

#3 MadMaxGR


    X-S Hacker

  • Members
  • PipPipPipPipPipPip
  • 2,815 posts
  • Gender:Male
  • Location:Cyprus
  • Xbox Version:v1.6
  • 360 version:v4.0 (jasper)

Posted 18 August 2011 - 01:47 PM

You must boot PS3 with HDD always. Otherwise it will nto boot.
If still have issue with YLOD or RLOD, then you must reflow the GPU, indeed.

#4 herman69


    X-S Young Member

  • Members
  • Pip
  • 53 posts
  • Location:Sunny Aberdeen, UK
  • Interests:Cars, Mapping cars, Drifting, Gaming, Reballing Consoles
  • Xbox Version:unk
  • 360 version:v3.0 (falcon)

Posted 29 August 2011 - 04:05 PM

For the blu-ray drive issue, simply open it up, re-allign everything to the eject position then put it back together, that should cure that problem.

As for the other issue, as above, you NEED a HDD plugged in for the console to work. Your problem is not an issue with the RSX if it powers up and you can see stuff on screen (even if the ONLY thing you can get on screen is the recovery menu).

I did one of these the other day, would turn on, then turn off after 30 seconds. The fix was to boot into the recovery menu and update the FW from a memory stick via the recovery menu. Console now works perfectly.

First fix the drive alignment then try and access the recovery menu. If you can get access, do an update, if not then the problem may well be with the RSX and a reflow may fix it.

However, in saying that, if the machine turns on and stays on, but there is no video AT ALL, even when going into the recovery menu then there is a good chance you have GLoD, which is basicallly a dead GPU and you need to replace the GPU with a known working one. GLoD is usually accompanied by not being able to turn off without using the switch at the back, but not always.

Edited by herman69, 29 August 2011 - 04:08 PM.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users