Jump to content


Photo

Rgh Jasper Freezing Randomly


  • Please log in to reply
5 replies to this topic

#1 webb789

webb789

    X-S Enthusiast

  • Members
  • 10 posts

Posted 20 November 2011 - 05:41 PM

hey everyone, i have just had my xbox modded with the reset glitch hack and am running freestyle dash 2 beta, now randomly my games seem to just freeze on me, this is not always the case.

The games freeze and then the console powers off, i have never had any issues with this xbox before the mod and the temps are fine.

what could be the problem? any help would be appreciated.

#2 keith6625

keith6625

    X-S Enthusiast

  • Members
  • 3 posts

Posted 29 November 2011 - 05:10 AM

i would ask your modder if he/she installed the 68nF Cap it helps boot times and freezing vary well they are even packing it with the coolrunner now

and make sure they kept the wires away from the coils


i would say this is a hardware issue not FSD

Edited by keith6625, 29 November 2011 - 05:12 AM.


#3 hakunamatatapl

hakunamatatapl

    X-S Enthusiast

  • Members
  • 6 posts

Posted 05 December 2011 - 12:56 AM

I have exactly the same issue. I have 68nF cap, i double check the wires and still my x360 freezing.

#4 webb789

webb789

    X-S Enthusiast

  • Members
  • 10 posts

Posted 05 December 2011 - 08:51 PM

it seems like if i leave the console on for a few minute before trying to load a game then it stops the console from freezing.

#5 Farid

Farid

    X-S Young Member

  • Members
  • Pip
  • 55 posts
  • Location:Iran
  • Xbox Version:none
  • 360 version:v4.0 (jasper)

Posted 13 March 2012 - 11:46 AM

I have the same issue with my Jasper 512, it freezes randomly inside of games. Boot time is 5.5 Sec. and about 100% it boots. No wires near coils. I used 681 on PLL and GND

#6 avenged06x

avenged06x

    X-S Enthusiast

  • Members
  • 4 posts
  • Xbox Version:unk
  • 360 version:v4.0 (jasper)

Posted 30 March 2012 - 03:20 AM

If it is a 512bb then these consoles are problematic for freezing. The wires underneath the MB have to be in the exact spot and or insulated or you will get freezing. Can be frustrating. But just move them around and be very careful as the wires if tugged on to hard can lift pads.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users