Jump to content


Photo

Re-jtag


  • Please log in to reply
1 reply to this topic

#1 sknobs

sknobs

    X-S Young Member

  • Members
  • Pip
  • 36 posts

Posted 09 February 2012 - 10:38 PM

Hey all.

Have an older Japser with the transistor JTAG. Just went RROD 0022. I am guessing Nand corruption.
I have the Nand-X reader JTAG kit from a while back.
Should I

a-solder in the Nand-x and reflash the nand back to stock and start over
b-Install the Nand-x and jtag without removing the old one?
c- remove the three wires from the old JTAG and install the Nand-x as per the tut?

thanks!!

#2 cRaCKwHoRe

cRaCKwHoRe

    X-S Senior Member

  • Members
  • PipPip
  • 271 posts
  • Xbox Version:unk
  • 360 version:v5.0 (360S - trinity)

Posted 10 February 2012 - 02:23 PM

If you suspect NAND corruption then solder in the NAND-X again and read the NAND several times and run it through and see if there are any bad blocks, mismatch, etc...

If there are- do you have your original NAND file? If so, you could build a new hacked image and flash it back..





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users